From MEP coordination to full VDC delivery — we model it right the first time so your project stays on budget, on time, and conflict-free on site.
Every service is scoped, coordinated, and delivered remotely with the same quality as an on-site team — at a fraction of the cost.
Intelligent, data-rich 3D models built to LOD 200–400. We deliver fully coordinated models that integrate architecture, structure, and MEP systems into a single federated file — ready for coordination, fabrication, and FM handover.
End-to-end mechanical, electrical, and plumbing coordination in a federated model environment. We resolve every spatial conflict before your crew arrives on site — reducing RFIs, cutting rework, and keeping your schedule intact.
Systematic clash detection using Navisworks and BIM Collaborate. We don't just find the clashes — we document, prioritize, and resolve them in coordination meetings so you receive a clean, conflict-free model every sprint.
Fabrication-ready shop drawings extracted directly from coordinated BIM models. Spool drawings, duct layout sheets, hanger and support details — all dimensioned, annotated, and formatted to your project standards.
Strategic Virtual Design & Construction consulting for owners, GCs, and specialty contractors. We set up your BIM execution plan, define LOD requirements, establish collaboration workflows, and run model reviews.
Link your schedule and cost data to the model for real-time construction simulation and quantity take-off. Visualize construction sequences, identify schedule risks, and generate material quantities — total control over time and budget.
Active in MEP and expanding. Architecture, Structural, and Steel are on our roadmap as we grow the practice.
Ductwork, air handling, fans, VAV boxes, diffusers, and all HVAC piping. Coordinated to clearance and code.
Domestic cold & hot water, sanitary, storm drain, gas piping, and fixture rough-ins to project spec.
Conduit and cable tray routing, panel layouts, lighting, power, and low-voltage systems fully coordinated.
Sprinkler layout and pipe routing coordinated with all trades. NFPA-compliant geometry and hanger placement.
Full architectural modeling and structural concrete to LOD 300–350 for federated coordination across all trades.
Steel framing, connections, and fabrication-level modeling for structural trade coordination and shop drawing production.
Tell us about your project and our BIM team will respond within 24 hours with a tailored proposal.